Caffélatex til slangeløs - Carbogrip

Carbogrip

Carbogrip is the perfect complement to Giustaforzatorque wrench. It is basically a special high-molecular weight silicone resin that, sprayed on a bicycle part before assembling it, polymerizes (in a time ranging from 3 to 5 minutes) into a grippy surface with the following characteristics:

CHARACTERISTICS:

 

prevents part slippage and the dangerous, normal reaction when a seatpost or handlebar slip at the recommended torque value: overtorqueing the bolts!

facilitates clamping of smooth carbon parts (handlebars, seatposts, aerobar extensions..)

the polymer also has anti-seize properties, allowing an easy component removal when needed

works great as threadlock (steel, titanium, aluminum, carbon bolts)

waterproof

very easy to use: no need for brushes as with other assembly pastes/liquids

ideal for mountain-bike grips: sprayed inside the grips it allows the grips to easily slide onto the handlebar when mounting, locking them in place when the resin polymerizes. The grips can then be removed blowing air inside them with a compressor, or with other procedures normally used to remove grips

can be easily removed with Carbomove or other petrol-based solvents

available in 75ml bottle size

Instructions for use:

 

Carefully clean/degrease the mounting surfaces. Seatpost: remove grease traces inside the seat-tube too

spray Carbogrip on the component and immediately mount it

tighten the mounting bolts to the suggested torque value

wait 5 minutes before using the component

unwanted Carbogrip traces can be removed with Carbomove or other petrol-based solvents

Tip: if not using Carbogrip frequently or forgetting to put the bottle cap after use, the resin could set inside the nozzle and blocking it. If so, remove the nozzle: a droplet of Carbomove (or other petrol-based solvents) inside it will restore its fuctionality.

 
Kontakt

B-BIKE

Kontakt: Rune von Moos

Tåstrup Hovedgade 92

2630 Tåstrup

Tlf: 26832368
Email: rune@b-bike.dk